Ford Brake Dust Shields

Quality and craftsmanship is excellent. It fits and works like the factory installed product. Downside like the factory parts they don't cut out the holes for the emergency brake adjuster and give a plug for the hole, so if you need to remove your rotor you can't back the adjuster off for easy removal. Installation is a little difficult because they don't make a two piece system for this vehicle. So you either have to press the spindle out and replace the bearings (this process isn't cheap or easy) or cut it in half were the heat slots are and weld it back together (may not have to weld it back together, but helps with rigidness). They give you four screws self tapping screws for each side. The factory only uses 3, but has four holes, so you have to you have to tap the fourth hole with the new screw. On other vehicles they sell them in singles instead of pairs. Unfortunately only needed one.